Run the LVSP1_f3Patchexe self-extracting executable and follow the prompts. Verify that the patch installs correctly. Select Help»About LabVIEW and look for f3 on the right portion of . 85 Line Follower Programming Guide (LabVIEW™ for LEGO® MINDSTORMS®): Part 1 Create a constant for the motor ports to tell the function which motors to drive. a. Right-click the Motors terminal and select Create Constant. Introduction. The sensor takes an average of the light reflected from a small area and outputs this value. When following a line, the light sensor needs to be lined up over the edge of the line: * Note: the values above are just for example--you need to test for yourself to see what value your sensor reads when it it centered over edge of your line.
Kazragal
In my opinion you are mistaken. I can prove it. Write to me in PM.